1/2" Plastic Zero Differential Solenoid Valve
Availability: In Stock
Technical Details
SKU
PSL-15
Position
Normally Closed
Port Size
1/2" Female NPT
Available Voltage
Select Above
Body Material
Engineered Nylon Plastic (PA66)
Components
Stainless Steel
Seal Material
EPDM Diaphragm
Orifice Size
15 mm
Temp Range
15 to 175° F / -10 to 80°C
Pressure Range
0 - 90 PSI (No Minimum Pressure)
Flow Rate
Cv 4.8 (Appx 36 GPM @ 60 PSI)
Power
AC: 20VA / DC: 20 Watts
Coil Connection
DIN 43650A
Coil Class
H Class - IP 65 - NEMA 4
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% (Continuous Duty)
*Suitable Media
Water – Air - Gas - *Etc
Weight
1 lb 1 oz
Height
4.21"
Length
2.99" port to port
Width
2.67"
Product Overview
Our PSL-15 line of Engineered Nylon Plastic electric solenoid valves are 1/2” semi-direct lift valves operating from a normally closed position. Normally closed valves stop the flow of media between the valves ports until power is applied, applying power causing the valve to open and media to pass through. This valve is unidirectional two-way valve which means it has two ports, one in which the media flows into the valve and the second where the media exits the valve. This is conveniently labeled with an arrow to indicate the direction of flow.
This valve has a 1/2” female NPT threaded port. It can handle media with a CST of 20 or below and has a flow rate of 4.8Cv (Appx 36 GPM @ 60 PSI). The EPDM allows this valve to handle a wider temperature range than NBR or Viton seals, boasting a temperature range of 15°F to 250°F and a pressure range of 0-90PSI.
The PSL-15 comes in 5 voltages, 12V DC, 24V DC, 24V AC and 110V AC Coils with DIN 43650A connection type and a H Class – IP 65 – NEMA 4 enclosure rating making it weather tight and good for either indoor or outdoor use providing a degree of protection against falling dirt, rain, sleet, snow, windblown dust, splashing water, and hose-directed water. These coils allow the valve to open and close almost instantly, with a response time of under 1 second making the valve reliable and accurate.
The valve body is molded from PA 66, Engineered Nylon Plastic, making it completely lead free and an ideal choice for controlling potable water or food grade applications.
A pre-filter is always recommended to keep the diaphragm free from debris and the valve functioning properly.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
