1" 12V DC Stainless Steel Solenoid Valve
Availability: In Stock
Technical Details
SKU
SZW-25-12VDC
Position
Normally Closed
Port Size
1" Female NPT
Voltage
12V DC
Body Material
Stainless Steel
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
25 mm
Temp Range
15 to 250° F / -10 to 120°C
Pressure Range
Water: 0-115 PSI | Air 7-115 PSI
Flow Rate
Cv 12 (Appx 92 GPM @ 60 PSI)
Power
18 Watts / 1.50 Amps
Coil Connection
Lead Wires
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% but not indefinitely
*Suitable Media
Water – Air - Fuel - *Etc
Weight
2 lbs 5 oz
Height
4.50"
Length
3.25" port to port
Width
2.60"
Product Overview
The SZW-25-12VDC is a 12 Volt DC, 1” Stainless Steel, 2-way Solenoid Valve. This valve is compatible with a variety of media such as air, water, gas, diesel fuel, weak acids and glycol. The valve features a solid stainless steel body with a Viton seal. It is suitable for temperatures from 15°F up to 250°F. This valve requires 18 watts from a DC power source typical to that of a car battery.
This SZW-25-12VDC has no minimum pressure requirements and can operate up to 115PSI. This makes it ideal for gravity fed applications. The orifice size of the SZW-25-12VDC is 25mm allowing a higher flow rate when compared to other comparable solenoid valves.
The valve includes a 12 Volt DC coil that has a voltage tolerance of +-10%. This coil requires 18 watts or 1.5 amps to operate the valve. The coil has 5.5” lead wire connections for easy installation.
Installation: The coil has no polarity making power and ground interchangeable. There is an arrow indicating the direction of flow on the stainless valve body. Installed with the coil up is the preferred method however the valve will operate in any position. A pre-filter should be installed to prevent the valve from leaking caused by debris.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
