2" 24V AC Electric Brass Solenoid Valve
Availability: In Stock
Technical Details
SKU
BZW-50-24VAC
Position
Normally Closed
Port Size
2" Female NPT
Voltage
24V AC
Body Material
Brass
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
50 mm
Temp Range
15 to 250° F / -10 to 120°C
Pressure Range
Water: 0 - 145 PSI | Air: 7-145 PSI
Flow Rate
Cv 48 (Appx 370 GPM @ 60 PSI)
Power
23 VA / 1.00 Amps
Coil Connection
DIN 43650A
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - Fuel - *Etc
Weight
6 lb 13 oz
Height
6.50"
Length
5.30" port to port
Width
4.25"
Product Overview
The 2” 24 Volt AC brass solenoid valve is our highest-flow normally closed valve in this configuration. This valve is configured with 2” female NPT input and output ports that can be easily connected with your own fittings. This valve utilizes a Viton diaphragm, which makes it compatible with a wide range of chemicals as well as temperatures up to 250°F. This valve is gravity-feed capable and requires no pressure to open or close.
This 2” valve requires no pressure to operate. This means it will work well in a gravity-fed system. The valve's operating pressure range is from 0 – 145 PSI. The orifice in this valve is 50 mm, and the Cv value is 48. For example, at 0 PSI, this valve will flow approximately 45 gallons per minute, and at 60 PSI, 345 gallons per minute.
Installation
- This valve requires 23 VA or 1.00 Amps from a 24 VAC power source.
- It can be connected directly by its lead wires. This unit is fitted with an IP54 coil, which makes it resistant to water. If installed outside, the valve should be covered to prevent the coil from getting wet
- The valve's body has molded directional arrows that indicate the direction of flow.
- The valve will perform best with the coil in the upward position.
- A pre-filter is recommended in your installation to keep the orifice free from debris to ensure a tight seal.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
