1-1/2" 12V DC Stainless Electric Solenoid Valve
Availability: In Stock
Technical Details
SKU
SZW-40-12VDC
Position
Normally Closed
Port Size
1-1/2" Female NPT
Voltage
12V DC
Body Material
Stainless Steel
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
40 mm
Temp Range
15 to 250° F / -10 to 120°C
Pressure Range
Water: 0-90 PSI | Air 7-90 PSI
Flow Rate
Cv 29 (Appx 220 GPM @ 60 PSI)
Power
40 Watts / 3.25 Amps
Coil Connection
Lead Wires
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% but not indefinitely
*Suitable Media
Water – Air - Fuel - *Etc
Weight
4 lb 14 oz
Height
6.00"
Length
4.33" port to port
Width
3.35"
Product Overview
The SZW-40-12VDC is a 12 Volt DC, 2 Way, 1-1/2 Inch Stainless Solenoid Valve. This valve is compatible with air, water gas, diesel fuel, glycol as well as various other media types. This valve is rated for media temperatures ranging from 15°F to 250°F and pressure ranging from 0PSI up to 90PSI. This is a normally closed unit meaning the valve will stay closed until power is applied. The 12 Volt DC coil requires a 12 Volt DC power source to operate.
The SZW-40-12VDC is a 1.5” inch stainless steel valve that has female NPT ports. The valve weighs approximately 4lbs, 14ozs and measures 6” tall, 4.33” port to port and 3.35” wide. This is a high flow solenoid valve with a 40mm orifice and Cv value of 29. This means the valve can flow approximately 220 GPM of water at 60 PSI.
The 12 Volt DC coil is included and required 40 watts or 3.25 amps to actuate. The coil includes lead wires for easy connection. The coil is rated for continuous use but should not be powered indefinitely.
The valve body is made of 304 Stainless Steel and it uses a Viton Diaphragm. These components are food grade and this valve can be used for potable water applications.
Installation: The valve is mountable in any position however coil up is preferred. The coil has no polarity and the wires are interchangeable with power and ground. There is a directional arrow on the valves body that represents the direction of flow. A pre-filter is recommended to prevent debris from entering the valve body.
This valve is commonly used by municipalities for fuel and/or water transfer.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
