1" Brass 3 Way Electric Ball Valve - 3 Wire
from:
$144.24
3/4" Brass 3 Way Electric Ball Valve - 3 Wire
Availability: In Stock
Technical Details
SKU
BVB5TV-XR33
Port Size
3/4" Female NPT
Wiring Type
3-Wire Power-driven open and close
Actuator
XR33 - 3 Wire
Actuation Method
Direct motor-driven
Voltage Range
Select Above (auto detects voltage)
Body Material
Brass
Components
Stainless Steel
Seal Material
FKM (Viton® equivalent)
Ball Seat
PTFE
Gears
Metal
Bore Type
15mm Bore
Flow
Bi-Directional
Media Temperature
35 - 200° F / 2 to 90°C
Ambient Temperature
-15-50°C / 5 - 120 °F
Pressure Range
0 - 185 PSI (No Minimum)
Max Torque
3 Nm
Closing / Opening Time
≤8 Seconds
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - Fuel - *Etc
Enclosure Rating
IP67 (NEMA 4 equivalent)
Weight
1.75 oz
Height
4.30"
Length
3.00" port to port
Width
2.56" (actuator)
Position Switch Time
5 Seconds
Fail position
Last position on power loss
Recommended Maximum Cycling Rate
≤ 3 cycles / min
Product Overview
If your looking to control the direction of flow this 3/4" brass electric actuated ball valve might fit the bill. It is connected by way of 3/4" NPT ports with an "L" type of configuration to switch positions. The valves body is cast from brass, the valves ball is 316 Stainless steel, the seal is Viton and the ball seat is PTFE. This combination makes this 3 way ball valve compatible with a wide array of chemicals. The valve does include a XR33, 3 wire actuator. This style actuator uses a constant power and ground while a third green wire is used for the control switch. The actuator does not generate heat which makes it superior to a solenoid valve because it will not burn out from long term usage.
This specific valve has a NEMA 4 housing and can be installed outdoors or other wet environments. Compared to a solenoid valve a ball valve has a much slower response time. The valve uses a mechanical ball with an orifice to change position. For this ball valve to change position it typically takes about 5 seconds, eliminating any water hammer. Another feature of motorized ball valves is the ability to run flow in any direction.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
Flow Diagram/Wiring Diagram
