3/4" UPVC Electric Ball Valve - 3 Wire
Availability: In Stock
Technical Details
SKU
BVP5CE-XR33-J
Port Size
3/4" Female NPT
Wiring Type
3-Wire Power-driven open and close
Actuator
XR33 - 3 Wire
Actuation Method
Direct motor-driven
Voltage Range
9 to 24V AC/DC
Body Material
UPVC
Components
UPVC
Seal Material
EPDM
Ball Seat
PTFE
Gears
Metal
Bore Type
Full
Pressure Range
0 - 185 PSI (No Minimum)
Media Temperature
35 - 130°F / 2 - 55°C
Ambient Temperature
5 - 120°F / -15 to 50 °C
Coil Connection
Lead Wires
Max Torque
3 Nm
Actuator Connection
Lead Wires
Closing / Opening Time
≤8 Seconds
Working Current
≤500 mA
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - *Etc
Enclosure Rating
IP67 (NEMA 4 equivalent)
Min. Energized Cycle
60 Seconds
Weight
9 oz
Height
4.43"
Length
2.85" port to port, 2.95" total
Width
2.56" (actuator)
Life Expectancy
70,000 Cycles
Fail position
Last position on power loss
Recommended Maximum Cycling Rate
≤ 3 cycles / min
Product Overview
9 to 24V AC/DC (auto detects voltage)
The model BVP5CE is a ¾” Motorized Ball Valve with a UPVC molded body. The molded plastic body has ¾” NPT inlet and outlet ports. The valve seals are EPDM and PTFE. This component combination makes this valve an excellent choice for both potable water and corrosive chemicals like salt water and acids. Since there are no wetted metal parts this choice is perfect when a metallic valve can’t be used.
This valve comes with a 3 wire control actuator that allows the position to be controlled with a momentary switch. The actuator required 9 to 24V AC/DC to turn the balls position. This actuator has an internal voltage detector that allows it work within the specified range. A minimum of 500 mA is required to rotate the ball. The valve can be left in either position without requiring consistent power. The valve also features a position indicator on top of the motor so the position of the ball can be seen.
Another great feature of Electric Ball Valves is the fact that they work Bi Directional, meaning the flow through the body can enter through either port. The ball takes approximately 5 seconds to switch position which eliminates water hammer. The valves NEMA 4 enclosure makes it suitable for spray day and other wet locations however it should never be submerged.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
