1" Stainless Electric Ball Valve - 2 Wire Auto Return
Availability: In Stock
Technical Details
SKU
BVS6CE-XR22
Port Size
1" Female NPT
Wiring Type
XR22 - 2 Wire Auto Return
Voltage Range
Select Above (auto detects voltage)
Body Material
304 Stainless Steel
Components
Stainless Steel
Seal Material
EPDM
Ball Seat
PTFE
Gears
Metal
Bore Type
Full
Flow
Bi-Directional
Temp Range
35 - 200° F / 2 to 90°C
Pressure Range
0 - 185 PSI (No Minimum)
Max Torque
2 Nm
Power
Working Current - ≤500mA
Coil Connection
Lead Wires
Closing Time
5 Seconds
Min. Energized Cycle
60 Seconds
Duty Cycle
100%
*Suitable Media
Water – Air - Fuel - *Etc
Enclosure Rating
IP67 (NEMA 4 equivalent)
Weight
1 lb 5.6 oz
Height
4.50"
Length
3.20" port to port
Width
2.56"
Life Expectancy
70,000 Cycles
Product Overview
Choose an XR22 wiring option above:
- 9 to 24V AC/DC (auto detects voltage)
- 110 to 230V AC
This 1" Stainless Motorized Ball Valve is a great choice for a variety of applications. Flow is not restricted through these valves and they are bi-directional, so media is capable of traveling in either direction. There is also no water hammer, as the open/close response time is 4-5 seconds. The valve body and ball is 304 stainless steel, while the ball seat is PTFE and the seal is EPDM. The lead free stainless steel body combined with the EPDM seal make it suitable for potable water applications. This specific electric ball valve is commonly used as a home emergency shut off valve.
Once power is applied to the valve XR22 actuator, the ball will turn until the valve is in the fully open position. The internal capacitor of the valve is also charged during this initial powering, over a period of approximately 60 seconds. A negligible amount of power is required to hold position in order to keep the internal capacitor charged. Once the power is cut or lost, the internal capacitor will use its power to close the valve completely. The actuator is rated IP67 and NEMA 4, making it resistant to splashes and sprays and compatible with outdoor use. Caution should be used during extreme weather conditions as the valve can be damaged. When mounting the valve, the actuator should preferably be up, especially during high degrees of vibrations. There are 20" lead wires extending from the actuator that can be used to power the valve.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
