3/4" Brass Electric Ball Valve - 2 Wire Auto Return
Availability: In Stock
Technical Details
SKU
BVB5CV-XR22
Port Size
3/4" Female NPT
Wiring Type
2-Wire Power-to-Open, Power-off-to-close
Components
Stainless Steel
Actuation
Capacitor-Assisted
Voltage Range
Select Above (auto detects voltage)
Body Material
Brass
Flow
Bi-Directional
Seal Material
FKM (Viton® equivalent)
Ball Seat
PTFE
Gears
Metal
Working Current
≤500 mA
Coil Connection
Lead Wires
Media temperature
35 - 200° F / 2 to 90°C
Ambient Temperature
5 - 120°F / -15 to 50 °C
Pressure Range
0 - 185 PSI (No Minimum)
*Suitable Media
Water – Air - Fuel - *Etc
Actuator Connection
Lead Wires
Closing / Opening Time
≤5 Seconds
Height
4.23"
Duty Cycle
100% Duty at Rated Ambient Temperature
Width
2.56" (actuator)
Enclosure Rating
IP67 (NEMA 4 equivalent)
Actuator
XR22 - 2 Wire Auto Return
Fail Position
Closed on power loss
Actuation Method
Capacitor-Assisted
Length
2.58" port to port
Recommended Maximum Cycling Rate
≤ 50 cycles/hour
Product Overview
Choose an XR22 wiring option above:
- 9 to 24V AC/DC (auto detects voltage)
- 110 to 230V AC
The BVB5CV is a brass body electric ball valve with a ¾” female NPT inlet and outlet port. Unlike most solenoid valves, this ball valve will allow fluid to flow in both directions, eliminate water hammer and requires minimal power to hold position. This makes it a popular choice as an emergency shut off valve that’s triggered in the event of a power failure.
The XR-22 Actuator controls the movement of the ball valve. It is available in a 9V to 24V AC/DC or 110V to 230V AC option. The actuator has the ability to auto detect voltage. The actuator has an internal capacitor that controls the auto return feature while no power is supplied. The actuator is rated IP67 or NEMA 4 equivalent making it resistant to splashes and strong sprays. We do advise the installer to use caution installing the electric ball valve outdoors as it can be damaged in extreme weather conditions. The internal capacitor powers the motor to turn the ball 90 degrees back to its normal position when power is removed. This actuator requires a minimum energized cycle of at least 60 seconds to ensure the internal capacitor is fully charged and has enough power to close the valve completely. Cycle times shorter than 60 seconds may result in partial or incomplete closures.
For convenience a position indicator is installed on the top of the actuator that will show you the position of the valve. It is recommended to install the electric ball valve with the actuator on top.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
Warranty
Electricsolenoidvalves.com guarantees our valves to be free from defects in workmanship and materials under normal use for One year from the date of purchase. For complete terms of this warranty see our Warranty Terms & ConditionsRelated Products
-
-
1" Brass Electric Ball Valve - 2 Wire Auto Return
from:$85.96 -
1/2" Brass Electric Ball Valve - 2 Wire Auto Return
from:$77.18 -
2" Stainless Electric Ball Valve - 2 Wire Auto Return
from:$517.09 -
1" Stainless Electric Ball Valve - 2 Wire Auto Return
from:$108.40
